E-mail: support@pickaudio.es
Shopping Cart 0
€0.00

Schoeps CMIT 5

€2,152.59 €1,779.00
Availability (5-10 days)
SKU
cmit5
Schoeps CMIT 5 Microphone

Description

The CMIT 5 is SCHOEPS' shotgun microphone which has set a new standard for shotgun microphones since its release. The CMIT 5's directionality increases smoothly with higher frequencies, which results in a very balanced sonic character. In addition to this, the microphone's sound level decreases softly yet steadily for off-axis sounds, allowing these to be recorded neutrally as well as reducing the effects of movement during boom operation. The CMIT 5 also has a much stronger directionality than one might expect from a microphone of its length. If required, the CMIT 5 can also be used for music recordings, for example opera recordings.

Practice

The sound quality of the CMIT 5 remains consistent even if the microphone is rotated on its axis, since its directional pattern is the same in both the vertical and horizontal planes.

Three pushbutton-activated filters allow the microphone to adapt to the recording situation:

  • High-frequency emphasis (+5 dB at 10 kHz) enhances speech intelligibility, and compensates for high-frequency loss caused by windscreens;
  • A steep low-cut filter (18 dB/oct. below 80 Hz) suppresses wind and boom noise;
  • A gentle low-frequency rolloff (6 dB/oct. below 300 Hz) compensates for proximity effect.

Pairs of LEDs next to each pushbutton indicate the status of the filters. Even in darkness the user can read the settings and see that the microphone is operational. The settings are retained when the microphone is switched off.

The capsule and amplifier of the CMIT 5 are built as a single unit, unlike microphones of the SCHOEPS Colette series.

Technical Specifications

Pickup pattern Supercardioid / lobe-shaped
Frequency range 40 Hz - 20 kHz
Sensitivity -35 dB (V/Pa), 18 mV/Pa
Equivalent noise level (A-weighted) 13 dB
Equivalent noise level (CCIR) 24 dB
Signal-to-noise ratio (A-weighted) 81 dB
Maximum sound pressure level (THD < 0.5 %) 131 dB-SPL (P48)
Maximum output voltage 1.3 V (2.5 dBV) with 1 kΩ load
High shelf filter switchable, +5 dB at 10 kHz
Low cut filter switchable, 80 Hz, 18 dB/oct.
Proximity filter switchable, 300 Hz, 6 dB/oct.
Minimum recommended load impedance 1 kΩ
Output impedance 50 Ω
Maximum cable length > 400 m
SCHOEPS RFI Shield Yes
Powering standard / Valid range P48 / >34 V
Current consumption 4.4 mA (P48)
Common mode rejection ratio (at 1 kHz) > 65 dB
Output XLR-3M, analog, 1 channel
Length 251 mm
Diameter 21 mm
Weight 95 g
More Information
Related documents:

CMIT 5 datasheet

Write Your Own Review
You're reviewing:Schoeps CMIT 5
Your Rating

Stock Messages
Stock: Item is available in our warehouse ready for inmediate delivery.
On Demand: Item served upon request. Shipment deadlines are approximated.
Temporarily Out of Stock: Item out of stock but usually in stock. Shipment time is less than 10 days.

Delivery Times
Delivery times are approximate, items are usually delivered before these times. Once your order you will receive an e-mail giving you a more accurate estimated time of delivery. If you would like to know the delivery time before placing an order, please e-mail pickaudio@pickaudio.es indicating references and quantities to be purchased. You will receive a reply in 24/48h.

Compare Products
You have no items to compare.