Remote Audio Speakeasy v4BT

REMOTE AUDIO SPEAKEASY V4BT BATTERY POWERED MONITOR W/ BLUETOOTH

The Speakeasy v4BT is a self-contained, battery-powered speaker with mic, line and instrument level inputs, and an integrated Bluetooth receiver for wireless playback of audio. It is housed in a cast aluminum enclosure with a durable black finish and features an improved audio signal path and upgraded power amplifier for better clarity and faithful sound reproduction.The Speakeasy v4BT drivers are magnetically shielded, allowing operation near sensitive equipment.

Powering

The Speakeasy v4BT will operate on two 9V batteries, typically for a full day of intermittent use. It will also operate from an external 9 - 18VDC power source on its coaxial power connector (2.1 x 5.5mm, center pin positive). The internal battery is switched out of circuit when plugging in external power so there is no need to remove the battery when using external power.

Line Level Input

The line level input is for balanced signals of +4dB, though unbalanced signals may be used. An XLR / 1/4" TRS combo jack is provided for convenience, and is wired in the standard balanced configuration of Pin 1/Sleeve = Ground, Pin 2/Tip: Audio Hot (+), Pin 3/Ring: Audio Cold (-).

Microphone Level Input

The XLR mic level input will accept a balanced mic level signal, and will directly accommodate a dynamic microphone. Powering for condenser mics is not available. The microphone input has 40dB of gain available, accessible on the rear panel with a small flat-bladed screwdriver.

Instrument Level Input

The Speakeasy v4BT will accommodate an unbalanced instrument-level signal on a 1/4" TS connector. The impedance of this input is 1Mohm, which is suitable for use with passive electric guitar pickups or active guitar preamp systems without "loading down" the pickups and causing high frequency roll-off. Instruments with very hot outputs, such as electric guitars with overwound humbucker pickups, may cause distortion. In that case, the guitar's volume control should be adjusted to minimize distortion. All audio inputs are isolated from each other and therefore may be used at the same time. For example, a line level input can be used for music playback while the mic input is used for cueing.

Bluetooth Operation

The Speakeasy v4BT is equipped with a built in bluetooth receiver module for wireless audio playback. It has a range of >30 ft. depending on the environmental factors. It features a simple two button interface with two status LEDs.

Applications

• Use on your cart to listen without headphones.
• Place it anywhere on set with a wireless receiver for cueing and stage announce.
• Plant it in a car during tow scenes so the director can talk to actors (when used with the Boom Box).
• Connect one (or two) to your computer or iPod for remote listening and editing.
• Monitor programming during remote radio and television broadcasts.
• Plant it inside a piano for realistic track playback.

Specifications

• Dimensions 4.6" x 4.5" x 7.3"
• Weight 4.4 pounds
• Internal Power Two 9V batteries
• External Power 9-18VDC
• Idle Power Drain ~70mA
• Amplifier Power 14W per channel
• Woover 8 Ohm nominal speaker impedance
• Tweeter 6 Ohm nominal speaker impedance
• Maximum SPL 96dB (1kHz @ 1m)
• Blutooth Version 5.0 certified
• Support A2DP v1.2, AVRCP v1.5 HSP v1.1
• Frequency Spectrum 2.402 GHz to 2.480 GHz
• Range approx 30 - 50ft depending on environmental factors