Schoeps MiniCMIT Previous Schoeps MiniCMIT

Schoeps SuperCMIT

€3,810.29 €3,149.00
close-red Out of stock
Schoeps SuperCMIT Microphone


The Schoeps SuperCMIT Digital Shotgun Microphone incorporates a unique design and approach to minimizing extraneous noise, increasing range and retaining the transparency and integrity of the source audio. The SuperCMIT features a dual output signal, coupled with digital signal processing for excellent noise diffusion and pristine transparency.

In addition the microphone features a low-frequency roll-off switch, high frequency gain switch and increased directivity switch for maximizing range. The Schoeps SuperCMIT is at home on a boompole or pistol grip mount, and is very well suited for ENG / EFP, broadcast applications, audio for video and motion picture, sound design applications and more.

  • - New type of digital shotgun microphone with increased directivity, based on Shoeps' extremely successful analog model CMIT 5
  • - Diffuse sound is suppressed to an extraordinary degree
  • - Completely new operating principle with two transducers
  • - Uses digital signal processing (DSP) algorithms from Illusonic
  • - Two-channel output, with SuperCMIT signal in channel 1 and (direct, single-transducer) CMIT signal in channel 2
  • - Schoeps sound quality: transparent sound


Especially where diffuse noise like street noise, wind noise, audience noise or room noise interfere with the recording, the SuperCMIT is a problem solver. While the direct sound is recorded without colorations, the noise is eliminated, that is, its level is significantly reduced - down to the lowest frequencies! This cannot be achieved even by a long shotgun microphone. Therefore, the SuperCMIT is ideally suited e.g. for difficult film sound recordings or for sports applications. The SuperCMIT also increases the range of shooting in indoor areas.

Technical Specifications

Pickup pattern Supercardioid / lobe-shaped
Frequency range 40 Hz - 20 kHz
Sensitivity -31 dBFS at 1 Pa
Equivalent noise level (A-weighted)

14 dB (channel 1)

16 dB (channel 2)

Equivalent noise level (CCIR)

27 dB (channel 1)

28 dB (channel 2)

Signal-to-noise ratio (A-weighted)

80 dB (channel 1)

78 dB (channel 2)

Maximum sound pressure level (THD < 0.5 %) 125 dB-SPL
Latency period

channel 1: 1.6-6.25 ms (frequency-dependent)

channel 2: 1.6 ms

High shelf filter switchable, +5 dB at 10 kHz
Low cut filter switchable, 80 Hz, 18 dB/oct.
Output impedance 110 Ω
Maximum cable length > 200 m
SCHOEPS RFI Shield Yes, highest immunity
Powering standard / Valid range AES42 / >6 V
Current consumption 170 mA

XLR-3M, digital: AES42 Mode 1, 48 kHz

Channel 1: SuperCMIT

Channel 2: Unprocessed shotgun

Length 280 mm
Diameter 21 mm
Weight 112 g
More Information
Related documents:

CMIT datasheet

Mensajes de Stock
Stock: Producto disponible en nuestro almacén para envío inmediato.
Bajo Pedido: Productos que únicamente se sirven bajo pedido. El plazo indicado de envío al cliente es orientativo.
Temporalmente Fuera de Stock: Producto agotado que habitualmente está en nuestro almacén. Tiempo de reposición para envío inmediato inferior a 10 días.

Plazos de entrega
Los plazos de entrega indicados son orientativos, no obstante los artículos se suministran habitualmente en un tiempo inferior al previsto.
Una vez realizado su pedido recibirá un e-mail indicándole con mayor exactitud el tiempo estimado de entrega.
Si desea conocer el plazo de entrega antes de realizar su pedido, envíenos un e-mail a indicando las referencias y cantidades que desea adquirir. Recibirá nuestra contestación en 24/48h.

Write Your Own Review
Write a ReviewSchoeps SuperCMIT
To Top